No Heat, Banging Radiators, Boiler Short Cycling: Heating Emergencies Brooklyn Homes Can’t Wait On
The boiler in a Bed-Stuy brownstone shuts off at 11 p.m. on the coldest night of January. The tenant on the parlor floor texts. The owner on the top floor goes down to the cellar with a flashlight and finds a red light on a control box nobody has ever read. Half the calls that start with a search for HVAC Brooklyn that night describe that cellar. MJ HVAC Brooklyn, 1290 Fulton St, Brooklyn, NY 11216, (929) 405-1919, runs no-heat calls across the borough all winter, and the common ones sort into a short list.
No Heat and the Boiler That Will Not Fire
The thermostat goes first. Dead batteries, a smart thermostat that lost its network, a schedule somebody changed. Then the emergency switch at the top of the cellar stairs, the one with the red plate, which a kid or a cleaning person flipped. Then the boiler itself. On a steam boiler the low water cutoff kills the burner when the sight glass runs low, and a boiler that lost water through a leaking return or a bad vent sits dark until someone adds water, slowly, never into a hot boiler. On a hot water boiler a dead circulator or a stuck zone valve leaves the boiler hot and the radiators cold. Older boilers with a standing pilot have a thermocouple that fails and lets the pilot go out. Newer ones with electronic ignition blink a lockout code on the control, and the code is on a sticker inside the jacket.
A gas valve that has failed or a National Grid lock on the meter are the two that nobody fixes at midnight. Everything else on the list is a part on the truck.
Banging Radiators and Water Hammer
A radiator that bangs like someone hitting the pipe with a hammer has condensate trapped where steam is arriving. Water sitting in a radiator pitched the wrong way, in a sagging steam main in the cellar, or behind a supply valve left half open. The steam slams into the water and the water slams into the pipe. The fixes are mechanical. Shim the radiator so it pitches back toward the supply valve. Open the valve all the way, since a one-pipe steam valve is either open or closed and nothing in between. Rehang the sagging main. Lower the pressure at the pressuretrol. Skim a dirty boiler that is throwing wet steam up the risers. Tenants call it an emergency at 3 a.m. and the owner hears it through the floor, but nothing is about to break.
Short Cycling and the Pressuretrol
A steam boiler that fires for two minutes, shuts off, waits, and fires again is cycling on pressure. Steam cannot get out to the radiators fast enough, so pressure builds at the boiler and the pressuretrol cuts the burner. The cause is almost always venting. Clogged main vents, radiator vents that never open, or a boiler sized for twice the radiation it serves. The fix is main vents on the ends of the steam mains, correct radiator vents, and a pressuretrol set to cut out under 2 psi. A boiler that cycles on the low water cutoff instead has surging water from oil in the boiler and needs a skim.
Hot water boilers short cycle on a tight aquastat differential, an airbound zone, or a failed expansion tank that sends the relief valve dripping every cycle.
Carbon Monoxide and the Flue
A carbon monoxide alarm is the one call where the advice is to leave first. Out of the house, 911 or National Grid from the sidewalk. The common causes are a blocked chimney, a collapsed clay liner in a 1910 brownstone chimney, a bird nest at the top, or a boiler backdrafting because a new kitchen exhaust hood pulls more air out of the house than the chimney can fight. The technician runs a combustion analysis, checks draft at the hood, and inspects the flue. A cracked heat exchanger or a boiler section leaking combustion gas is a replacement, and the utility will lock the gas until it happens.
Frozen Pipes on the Heating Side
Hot water baseboard in a rear extension over an unheated crawlspace freezes first. So does a steam condensate return running along a cold cellar wall or a wet return buried under a slab that has heaved. A frozen return stops the boiler on low water. A frozen baseboard loop stops one zone. Thawing is slow and careful, and the repair afterward is insulation and heat where the cold got in, since the same pipe freezes again in February. A space heater left in the crawlspace for one night is the wrong answer and the one everybody uses.
Heat Season Rules and the Landlord’s Night
Heat season runs October 1 through May 31. Between 6 a.m. and 10 p.m., when the outdoor temperature is under 55, apartments need 68 degrees. Overnight the floor is 62, regardless of the weather outside. Hot water at 120 all year. A tenant with no heat calls 311, HPD inspects, and a violation follows, and HPD’s emergency repair program will send its own contractor and bill the owner if the heat stays off. Landlords of brownstones carved into three or four units carry maintenance plans for that reason, with the fall tune-up in September and a technician who knows the boiler before the night it quits. A boiler that fails on a Friday gets fixed over the weekend at the weekend rate, and a landlord who waits for Monday pays the violation and the rate.
What an Emergency Heating Call Costs in Brooklyn
After-hours rates run higher and cover the trip. A thermocouple, an ignitor, a low water cutoff or a pressuretrol is a part and an hour. A circulator or a zone valve is a part and a longer hour. A skim takes patience more than parts. A boiler with a cracked section or a failed gas valve on a 30-year-old unit is a replacement with a DOB permit, scheduled for the next day while the house runs on space heaters.
MJ HVAC Brooklyn at 1290 Fulton St answers no-heat calls across Bed-Stuy, Clinton Hill, Crown Heights, Fort Greene, Park Slope and Flatbush. (929) 405-1919.
MJ HVAC Brooklyn
1290 Fulton St, Brooklyn, NY 11216
(929) 405-1919
https://mjhvacbrooklyn.com